H.A.R.M. Racing SX-3 010 Champion Edition

H.A.R.M. Racing SX-3 010 Champion Edition

After a lot of engineering work and tests we are now in the position to present the SX-3 – 010 as a completely reworked chassis concept.

Since the last update of the SX-3 in 2007 development with H.A.R.M. has not been stopped. As it is not easy to improve a successful concept development has taken a lot of time. With the new chassis concept special attention has been paid to the flexing of the car and also the stability has been improved.

The H.A.R.M. Racing SX-3 010 is based on a 8 mm thick chassis plate made of high quality aluminium. Due to several cut outs the weight is just 20 g higher than the weight of the existing chassis plate. Flutes on the bottom reduce the contact surface when the chassis touches the ground. The position of the front bumper is higher and the chassis plate is bevelled in this section in order to prevent contact of the front bumper with the ground.

The servo plate forms a unit together with the receiver box and receiver battery. This facilitates maintenance considerably as the servo plate is fixed just with 4 screws.

The upright carbon reinforcements provide more stability and influence the flexing behaviour of the car very positively. The transmission bracket is also connected to the front part of the vehicle by means of a carbon fibre reinforcement which facilitates equal flexing of the car.

The front bulkheads facilitate change of the roll centre in order to adjust the chassis for any track conditions and/or driving behaviour. They are also fixed longitudinally, the same as the connection to the middle section of the chassis.

All these measurements and modifications lead to a very equal flexing behaviour of the chassis and therefore to a well-balanced driving behaviour.

  • pre-mounted chassis, all screws fixed with Locatie
  • torx screws made of stainless steel
  • detachable front bumper
  • carbon fibre front body mount
  • CNC milled chassis made of high-strength aluminium
  • adjustable alloy front bulkhead
  • servo saver with ball bearing
  • precision linkage steering
  • precision track rod with alloy ball ends
  • alloy a-arms front
  • alloy ball ends with all a-arms
  • adjustable ball stabilizer front
  • alloy axle hub front, light
  • driving axle front in titanium
  • hubs in titanium
  • all turn buckles in titanium
  • alloy damper plate front
  • damper quick release
  • precision oil damper
  • carbon fibre stiffener 3 mm
  • carbon fibre servo plate 3,5 mm
  • alloy a-arms rear
  • adjustable stabilizer rear
  • 4-disc differential
  • two-part differential mounts
  • alloy transmission shaft hardened
  • alloy damper plate rear
  • alloy reinforcement a-arm rear
  • double rear support including brace
  • ball drive
  • alloy axle hub rear, light
  • Fuel tank with retractable tank lid
  • 3-hole motor mount, self-centering
  • H.A.R.M. tuning motor HRP03
  • air box set “open up” made by Mielke
  • Mielke Hurrican pipe set with masterfix
  • high-tech hydraulic brake front and rear
  • basic set-up

This equipment leaves nothing to be desired…..

Complete right from the start!

Measurements

H.A.R.M. Racing SX-3 010 Technical Data

Wheelbase:    535 mm

Length:           890 mm

Width:             395 mm

Weight:           ca. 9,9 – 10,4 kg

Back to Top

Kyplex Cloud Security Seal - Click for Verification